CARTOP MOOK EVO Vol.01 — Toyota Mark II/Chaser/Cresta Tuning & Dress-Up (May 1999)
An archive project by Flock MFGNew issue alerts →
About this issue
CARTOP MOOK EVO Vol.01 is a May 1999 tuning and dress-up guide to Toyota Mark II, Chaser and Cresta (JZX80/90/100). It covers Tourer V and JZX100 circuit and shop-car impressions, tuner and owner builds, aero and wheel catalogs, component tests, a TRD parts-development story, model history, suspension and muffler tests, parts catalogs, and reader submissions.
Page 101 — English draft translation
Captions and page details
Making Project
Tourer V
JZX100 Chaser
Give it a more distinctive, dressed-up look!
choose WALD
For aero parts,
evo
WALD Sports Line
The shop that did the work
Front spoiler: ¥48,000. Side skirts: ¥68,000. Rear spoiler: ¥48,000.
Garage Trust, Sagamihara, Kanagawa. The shop handles aero installation and bodywork. Representative Nishimoto is described as approachable, and the shop accepts both custom and general customer requests. Address and phone are shown below.
0726-73-3000
Source cooperation: Sauber World Japan
Toyota's strong sales mean that the JZX100 is now common on the road. To make this Chaser stand out, the editors chose aero parts. Their Tourer V already had the factory full-aero option, but many owners add aftermarket pieces to change the look.
Aero-parts installation
Before painting, prepare the surface and smooth out uneven areas; the finish depends on this work.
Allow the material to cure, fill the openings, and prepare the surface for paint.
Apply primer to the prepared surface, including the openings and edges.
Check the identification label near the passenger seat; it lists the vehicle's factory color code.
First, check the paint color against the sample; the work uses a multi-stage painting process.
The WALD aero kit gives the car a lower, more planted appearance. The set shown consists of four pieces: front, side skirts and rear components.
Use the special cleaning liquid to remove residue and oil after sanding.
Wet-sand the surface by hand until it is smooth and ready for paint.
After priming, wet-sand the surface flat; this step is important to an even finish.
Wet-sand the surface by hand until it is smooth and ready for paint.
Remove sanding residue and oil with the special cleaning liquid.
The paint and installation work were done at Garage Trust in Sagamihara. The article praises the shop's careful work and says that choosing quality parts for their design and finish, rather than price alone, is part of a mature approach to customizing the car.
Apply the primer evenly, taking care to cover small imperfections, then finish the surface preparation.
Apply primer, then paint. About 1.5 kg of material is used over roughly five coats.
Protect the painted surface so the finish retains its gloss.
Fit the front lip beneath the bumper and secure it with washers.
The mounting bolts are needed to secure the part; use the supplied bolts and fasten both sides.
Finish the surface preparation
With the work complete, finish and check each aero component.
Apply double-sided tape, align both sides carefully, and attach the part in position.
The part is secured with the special screws supplied for the installation.
Set the correct position and attach the spoiler.
101