Drift Tengoku — November 2006
An archive project by Flock MFGNew issue alerts →
About this issue
Bonnet design and modification take center stage, with carbon and FRP options, cooling comparisons, ducting, fitment, and DIY work. Other features cover a rear-wheel-drive GC8 Impreza conversion, Japanese drift builds, and American 240SX, RX-7, and 350Z projects.
Page 173 — English draft translation
Captions and page details
Planning to buy parts? Must read!
Reader testers report installation and real-world results!
Report
Monitor report
All three tested parts they'd long wanted, devised fitting solutions and clearly reported driving changes. They're good writers too — keep this up and the editorial staff could lose their jobs!
I mainly enjoy street drifting and don't seek a huge turbo-swapped power car, but my JZX100 felt slower than my old JZX90, so wanted a modest increase. Replacement required removing two exhaust-side flange bolts and three outlet-side nuts…
π+°
…trying to tighten the outlet flange from below as before, the bellows obstructed access…
[Heading fragment damaged.]
Felt more than a ten-horsepower gain!
The Rev Catalyzer has a bellows section to absorb impacts when the exhaust contacts the road. It can also reduce stainless-manifold cracking.
REPORT
Kitakami, Iwate
Yoshinobu Chiba
Inspection-compatible, with documentation, for peace of mind!
803-5753-8201
Price: ¥76,650. Supplied by Weds Sports .
June issue test item: Weds
REV CATALYZER
…so I used a ratcheting ring spanner from near the master cylinder, then checked flange leaks. After a little bedding-in, I drove: first outing this season, initially nervous, but stronger power from low to high rpm made drifting easy. Magazine comparisons suggested about ten horsepower over a stock catalyst; I felt even more.
…you see. [fragment]
Inspection documents mean no swapping back to the stock catalyst each time, unlike a straight pipe, and no police trouble over it — pleasing… [tester's opinion as printed].
…indeed.
Rev Catalyzer has a smaller catalyst volume and fewer cells than stock, suggesting better flow. Stainless yet lighter than factory.
Replaced at an acquaintance's gas station. Broken lift meant raising the front on rigid stands. Took around 40 minutes, likely less with a working lift and easier nut access.
A word from the manufacturer
I avoid unnecessary revs, so sometimes rear grip begins returning. Now a throttle press produces clean revving and maintains the drift.
Many thanks to Weds for supplying it, Masanori and Abe for helping, and Takuchan for photographs!
Glad performance exceeded expectations. Rev Catalyzer was developed as a legal tuning part combining power and emissions performance. Emissions testing filed; use the supplied documents for inspection. Keep drifting and enjoy its performance! [Manufacturer statement.]
Sugita, Weds
Yoshinobu Chiba's evaluation, JZX100 Mark II: would buy with own money; ease of installation; drift contribution; others' reactions [rating headings].
Printed ratings/comments: expensive but worth buying for legal power; easy enough for women to replace; stronger throughout the range; hidden underneath so unnoticed unless mentioned; legal power-up — good job, Weds! [Some star counts damaged.]
Satisfaction
171