Drift Tengoku — November 2006

Drag a corner or click a page to turn it

An archive project by Flock MFGNew issue alerts →

/ 284

About this issue

Bonnet design and modification take center stage, with carbon and FRP options, cooling comparisons, ducting, fitment, and DIY work. Other features cover a rear-wheel-drive GC8 Impreza conversion, Japanese drift builds, and American 240SX, RX-7, and 350Z projects.

Browse all magazines

Page 175 — English draft translation

18.

Still dreamlike after winning, I opened the delivered package eagerly. First impression: solid construction, thick throughout, especially mounting points and corners. Trial fit was excellent; only slight work at the skirts' bases. Aero-less cars' black lower-door molding interferes, requiring trimming or factory painted molding for aero-equipped cars. After trial fit, surface preparation and degreasing readied paint. A paint shop mixed to the color code; about three hours' spraying produced a very good finish despite a reportedly difficult color…

Captions and page details
1.

Reader monitor report [heading partly damaged]

5.

REPORT

4.

Kita-ku, Tokyo

3.

Satoru Ito

2.

Before fitting: aftermarket wheels, but no factory aero and coilovers that wouldn't lower further after a poor choice. It looked like an older man's car, hardly a drift car.

6.

Captivated by…

7.

…the ground-hugging stance!

8.

Dream aero transforms an old-man's car into a drift car!

15.

…¥41,790.

13.

Side steps / rear bumper: ¥31,290 each

12.

Price: front bumper…

10.

July issue test item: Rasty

14.

8047-441-6226

11.

Supplied by Rasty

17.

D-Spec CK aero

16.

eOGL

9.

After spotting a Chaser with D-Spec full aero near work, I'd wanted it. Winning felt like using up not only my lifetime's luck but my grandchildren's too!

19.

Tips for a clean pearl finish: stir thoroughly for even pearl distribution and spray several thin, even coats at constant speed without stopping, avoiding runs…

20.

…that's the method.

21.

…then clear coat. Because front stone chips are likely, several thicker clear coats were applied. Finished car looked wonderful! It sits close to the ground, but carbon material in the lip should resist scraping — too precious to test. Teammates praised its size, aggressive appearance and genuine good looks.

22.

Sanded with 400- and 800-grit to aid adhesion, then carefully degreased with neutral detergent. Surface preparation took about five hours…

23.

The characteristic carbon front-lip section is broad and looks strong. Translucent paint to show the material could be fun.

25.

…in total.

24.

Satoru Ito's evaluation, JZX100 Mark II: value, fitting ease, drift contribution and others' reactions.

28.

A word from the manufacturer

26.

Printed comments: design, quality and price all convincing; bumper/registration seal removal was difficult; instantly looks like a drift car; even a gas-station attendant called the Mark II big; plenty of impact without further lowering. [Some star counts damaged.]

27.

D-Spec CK uses carbon/Kevlar across the lip, resisting cracking when lowered and scraped, popular with drifters. It looks low and large but retains ground clearance for street use. Keep enjoying drifting without worrying over aero damage! — Arita, Rasty [manufacturer comment].

29.

Satisfaction

30.

173