Drift Tengoku — May 1997

Drag a corner or click a page to turn it

An archive project by Flock MFGNew issue alerts →

/ 180

About this issue

1997 drift-car tests featuring a Skyline GTS25t and Soarer sit alongside an Osaka drift-scene report, driving techniques, troubleshooting and suspension setup. Other features cover an Ebisu Circuit beginner track day, the KAAZ Powerpot LSD and drift-team cars.

Browse all magazines

Page 35 — English draft translation

1.

Excessive lowering causes more than tire-to-fender contact. Tires can rub places they must not touch, producing mysterious faults. Ignore wiring and you risk a fire and total loss! People who love extremely low cars have often removed the fender liners because the tires rub noisily. You may think that solves everything, but now the tires can touch something more serious. Have your wipers moved by themselves or your horn sounded continuously while driving? Remove the tire and inspect the upper inside of the fender. You may find the thick wiring harness...

10.

Don't wait until trouble occurs! If the tire rubs enough to wear a hole in the liner, remove it and inspect the wiring behind it. If rubbing has exposed the wires, insulate them with electrical tape or similar material before a short occurs. Again, there is a fire risk, so do this thoroughly. Then secure the harness firmly to the body with cable ties or similar fasteners. It can be surprisingly loose; holding it as high as possible should largely solve the problem. Retaining at least that part of the fender liner as a direct barrier is better still. If it continues to rub, the remaining answer is to raise the ride height.

19.

In my case... I've folded the fender lips on every car I've owned, as soon as I bought it. If you thoroughly warm the fender with a heater before hammering, you can fold it without cracking the paint. I've probably done more than ten cars for people. Kei OFFICE stunt-driving team: Yasuyuki Kazama. I put a thick steel pipe between the tire and fender and roll it around. At the rear, put people in the trunk and move the car backward and forward, and the fender folds neatly...

Captions and page details
4.

“The wiring is shredded...

3.

...and the strange behavior won't stop!”

6.

Broken wiring harness

5.

CASE2

9.

...tuning

8.

Preventive...

11.

Secure the wiring harness firmly

2.

Stop The TROUBLE!!

7.

...worn through, exposing the copper wires. Important wiring runs behind the fenders. Depending on the model, it may serve engine controls, lights or other systems. Broken wires can cause mysterious engine problems or troublesome faults. At worst, a short circuit can cause a fire. If this sounds familiar, check it.

15.

On this 180SX, the harness is pulled as high as possible with cord. With precautions this thorough, even an extremely low car should avoid rubbing.

17.

Oh... [Damaged short caption]

12.

This is a thorough solution. See the harness ahead of the strut tower? Rerouting it through the engine compartment eliminates the chance of tire contact.

23.

Day [Isolated character]

28.

11

27.

Three [Isolated character]

13.

...rubbing through can cause more than an open circuit; it is dangerous. Think of the consequences...

16.

A harness contains many bundled wires, so rubbing through can cause shorts as well as broken circuits. Take the trouble to insulate it properly to prevent later problems.

18.

Experience

21.

...from experienced drivers

20.

。.

25.

...that's how it's done!

26.

Nomuken

24.

OURAS

30.

OPTION2

29.

33