Drift Tengoku — November 2006

Drag a corner or click a page to turn it

An archive project by Flock MFGNew issue alerts →

/ 284

About this issue

Bonnet design and modification take center stage, with carbon and FRP options, cooling comparisons, ducting, fitment, and DIY work. Other features cover a rear-wheel-drive GC8 Impreza conversion, Japanese drift builds, and American 240SX, RX-7, and 350Z projects.

Browse all magazines

Page 41 — English draft translation

Captions and page details
3.

The bonnet Kita received from a friend had ducts directly above the strut towers, letting rain strike the upper mounts. His damping-adjustment dials seized. He filled those ducts with body filler.

2.

Kosuke Kita, Overflow . Bonnet: unknown. Block unnecessary ducts!

4.

Protect the important parts—

5.

—at least!

8.

A URAS C-cup protects the crank-angle sensor from rain. It will not necessarily fail the moment it gets wet—

7.

Fukada specification. Origin.

6.

Masahiro Fukada

10.

Bonnet fitted

11.

Rain protection—

9.

—but he dislikes electrical parts becoming soaked, so bought it when changing the bonnet. He also made a panel covering his mid-mounted intercooler and radiator. It looks good too.

12.

—what do you do?

13.

Here is a homemade cup substitute: a cut-down empty can placed over the crank-angle sensor. The car belongs to Fukuyama of F-NS. A red cup on the yellow cam cover shows distinctive color sense!

14.

Homemade from corrugated plastic!

15.

Matsuoka made a waterproof cover from corrugated plastic rather than buying one. It resists water, bends easily and is inexpensive. Black looks tidy; hook-and-loop tape makes it quickly removable, unlike screws that can become a chore.

16.

Dedicated covers handle the rain!

17.

The MASA bonnet has huge ducts on each side. Kitayama uses its dedicated rain covers because rain otherwise strikes the engine directly. He generally leaves them fitted except during circuit driving. They still allow some airflow, so he reports acceptable coolant temperatures outside full-throttle circuit use.

18.

Masaki Matsuoka

19.

MASA Motorsports

22.

Bonnet fitted [truncated label]

20.

An insider tip from Origin’s Watanabe!

21.

The Origin bonnet exhausts heat at the rear and has a hollow structure. Rain can collect inside it, says Origin publicity representative Watanabe, but a small drain hole lets it escape. The hole goes in the enclosed pocket near the front edge; the photograph is difficult to see.

28.

Origin publicity. Origin.

27.

Masato Watanabe

26.

Bad Line

25.

Kyogo Kitayama

30.

MASA Motorsports

31.

Bonnet fitted [damaged label]

29.

Bonnet fitted

33.

Photography: Masahisa Fujita / Drift Tengoku

32.

39