Drift Tengoku — November 2006

Drag a corner or click a page to turn it

An archive project by Flock MFGNew issue alerts →

/ 284

About this issue

Bonnet design and modification take center stage, with carbon and FRP options, cooling comparisons, ducting, fitment, and DIY work. Other features cover a rear-wheel-drive GC8 Impreza conversion, Japanese drift builds, and American 240SX, RX-7, and 350Z projects.

Browse all magazines

Page 70 — English draft translation

10.

Disconnect the coil connectors and remove the coils (photo 1), using a 10 mm socket. Disconnect the blow-by hose. Remove the cam cover (photo 2), also with a 10 mm socket. Loosen the bolts from outside toward the center. Keep the gasket clean. Ideally replace it, though the article says an undamaged example can be reused (photo 3). Apply liquid gasket at the half-round arch areas during refitting. [Historical procedure.]

21.

—otherwise rotate the crank once more. Mark the chain links at the timing marks and count between them: OCR says nine links here, while the diagram label says eleven; confirm the printed diagram before using the figure. Confirm No. 1 intake and exhaust cam lobes face outward and do not depress the valves (photo 4). Cable ties can retain the chain to prevent it slipping; working on one side at a time also reduces that risk (photo 5).

Captions and page details
1.

Almost the same as—

4.

—fitting cams—

5.

—as a job!

3.

—procedure

2.

Removal/refitting—

7.

Work precautions

6.

Work precautions: set No. 1 piston to compression top dead center before starting; check ignition timing afterward; always use a torque wrench for camshaft removal/refitting; keep debris out of the engine. [Magazine’s historical workshop instructions.]

9.

Remove the cam cover

15.

—loosen them [continuation of cam-cover bolt instruction].

8.

11 links .

12.

Confirm No. 1 piston at compression top dead center

16.

1. Turn the crankshaft slowly using a 27 mm socket and breaker bar (photo 1). [Historical procedure.]

18.

Turn until the crank-pulley mark aligns with the front-cover pointer. The mark is second from the left; highlighted in photo 2 for clarity. [Historical procedure.]

17.

2. Check the timing marks

20.

The cam-sprocket dot marks should be in the positions shown in photo 3—

19.

3. Check cam-sprocket and chain positions

22.

—then it is correctly positioned [sentence continuation].

23.

68